CISCO路由器配置手册-HDLC

CISCO路由器配置手册

一、HDLC

HDLC是CISCO路由器使用的缺省协议，一台新路由器在未指定封装协议时默认使用HDLC封装。

1. 有关命令

端口设置

注:1.以下给出一个显示Cisco同步串口状态的例子.

Router#show interface serial 0

Serial 0 is up, line protocol is up

Hardware is MCI Serial

Internet address is 150.136.190.203, subnet mask is 255.255.255.0

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255

Encapsulation HDLC, loopback not set, keepalive set (10 sec)

Last input 0:00:07, output 0:00:00, output hang never

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

Five minute input rate 0 bits/sec, 0 packets/sec

Five minute output rate 0 bits/sec, 0 packets/sec

16263 packets input, 1347238 bytes, 0 no buffer

Received 13983 broadcasts, 0 runts, 0 giants

2 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 2 abort

22146 packets output, 2383680 bytes, 0 underruns

0 output errors, 0 collisions, 2 interface resets, 0 restarts

1 carrier transitions

2. 举例

本文来自网络，不代表182手机网立场，转载请注明出处：https://www.182shouji.com/html/happy/2021/0308/176826.html

标签:CISCO路由器

【声明】：182手机网内容转载自互联网，其相关言论仅代表作者个人观点绝非权威，不代表本站立场。如您发现内容存在版权问题，请提交相关链接至邮箱：bqsm@foxmail.com，我们将及时予以处理。

OPPO Find N展开一刻，两大创新技术打破折痕路上意难平